These saginaw transmission support braces help prevent cracked ears due to the rough conditions seen in racing.

• Made from 1/4" steel

• Powedrcoated gloss black

• All grade 8 fasteners included

• Works with both the typical 4 bolt & the 5 bolt saginaw cases.

• If desired, these can also eliminate the need for a typical rear cross member mount making install & removal of the engine & transmission simpler

Installation notes & tips

• The hex nuts included are used as spacers for the 1/2" bolts & go between the support brace and your transmission.

• The brace can be installed with the trans already in the car if you have the tunnel clearance for it.

• It is recommended  to get all bolts started first then tighten the front two, followed by the rear two, & finally the one on the side. The side hole is slotted horizontally to allow this.